Farmall Cub Forum
Thu Feb 14, 2013 9:07 am
That support is not a casting but plain old schedule 40 pipe cut to length and bent to shape with holes drilled into it along the way.
Thu Feb 14, 2013 10:46 am
when making the pipe it was hot rolled. then run through a die to size and straigten.Along with lettering the pipe. I worked with the rail road back in the early 70's to late 90's. The youngstown sheet and tube was a 7 mile long mill. . Even had a coke mill. It is all gone. It was a awsome place to work around. A lot of people say the unions caused the sheet and tube to close. BUt in reality it was the EPA that nailed to coffen shut. Close to 8000 jobs lost plus the ripple down . There is a couple small mills still going but nothing like back in the day.
Thu Feb 14, 2013 6:56 pm
I recently looked at one that was a factory pipe, but had about 1/8" of the thread left on the steering rod block end. They must have JUST gotten to the end of the pipe on that one!
I found it interesting that they were using pipe with threaded ends.
Powered by phpBB © phpBB Group.
phpBB Mobile / SEO by Artodia.