Sun Feb 17, 2013 9:11 pm
Has anybody ever seen one of these work. If so are they good mowers? I saw where Rhino has taken over and parts are somewhat available. I picked this up yesterday and would like to put it on a Cub and get some use out of it.
Sun Feb 17, 2013 10:11 pm
I have not seen anything that resembles that . Good find Bill
Sun Feb 17, 2013 11:03 pm
I had on on a farmall A a few years ago. It seems to me it was a 6 ft mower. It cut well but if I remember right the spindles were not greasable.It also seem to take a lot of power to run compared to a woods or a IH C-3.
Mon Feb 18, 2013 7:00 pm
Here is the tag that is attached to the mower.
Mon Feb 18, 2013 11:51 pm
the tag on the one I had was missing. I really didnt know what kind of mower it was till I saw your picture. the one I had was a lot more than 5' wide.
Tue Feb 19, 2013 4:09 am
I have one..Got it for a real deal from John Nussbaum that lives close to me.Cuts great...better than push mowing for sure.Got the blades off.....need sharping.I run over it to put it on and take off.Real happy on the deal....still giving eggs for it.3 evenings to push mow or 3 hours with this on my 49...Life is good!!!! Kevin
Tue Feb 19, 2013 3:00 pm
I posted a photo of one I had a few years ago, folks seem to think it was homemade. It had a bad mule drive pulley bearing so I tried only a few times. Worked well. Mine had blades that were raised in the center. No need for it so it went to the scrap yard a few months ago but appeared to be a usable design.
Powered by phpBB © phpBB Group.
phpBB Mobile / SEO by Artodia.