Fast Hitch Point Size

Sun Mar 17, 2013 2:38 pm

Wondering if the points for Cub implements are the same size as the small (300/350) size points? John

Re: Fast Hitch Point Size

Sun Mar 17, 2013 2:50 pm

cub has the large points, SC 200 etc has the small points

Re: Fast Hitch Point Size

Sun Mar 17, 2013 2:57 pm

Wow, that was fast!! Do you ever leave your computer? So the Cub point is the 400/450 size, or were there three sizes? John

Re: Fast Hitch Point Size

Sun Mar 17, 2013 3:01 pm

Yes I do leave it , but when I do there are lots of questions :D

Re: Fast Hitch Point Size

Sun Mar 17, 2013 3:09 pm

I had asked Boss this question just the other day. It's my understanding there are two sizes. Cub uses the same as 300 and up.

Re: Fast Hitch Point Size

Sun Mar 17, 2013 3:34 pm

Thanks for the quick answers. I have a frame for a post hole digger with small points. Just wondered if they would fit a Cub. John

Re: Fast Hitch Point Size

Sun Mar 17, 2013 4:07 pm

There was a shim made to allow the use of small points in the large receiver. I've never seen one, so I can't give a description or the dimensions. I'll bet there is someone on here that can, though. :D

Re: Fast Hitch Point Size

Sun Mar 17, 2013 4:14 pm

There was a photo of a SHIM in the issue of RED POWER magazine that covered FAST HITCH implements. Basically, it was just a flat piece of steel that was held in the bottom where each prong slides into. It allowed you to use the smaller size prongs with the larger FAST HITCH.


Baldwindiesel

Re: Fast Hitch Point Size

Mon Mar 18, 2013 5:49 am

If I remember right, the shim is 1/4" thick x the width of the points. Had a FH Sickle mower I used with a 450D, then a 560 I had. John