Measurement Needed

Thu Apr 18, 2013 6:02 pm

My cub has the front axle off and is backed against a trailer SO....I need the distance between the rear cultivator tool bars. I rooted around and found some flat stock to make the "U" shaped brackets to mount my Wigle hoe. I figure that the "scratchers" must be able to almost touch if their mounting bar is running straight back and if my math isn't to bad I can subtract (or is that square root??) the distances and wouldn't be off by more than a few yards :roll:

Re: Measurement Needed

Thu Apr 18, 2013 7:11 pm

My tool bars are 24" inside to inside of the bends. If you want to clamp another bar onto the straight sections of the cult tool bars, the distance would be at 30". Hope that isn't too confusing.

Rick

Re: Measurement Needed

Thu Apr 18, 2013 7:20 pm

Here's a quick sketch of what I was trying to describe:
cult.jpg


Rick
You do not have the required permissions to view the files attached to this post.