Page 1 of 1

Will this fit my Cub??

Posted: Tue Apr 23, 2013 8:16 pm
by ricky racer

Re: Will this fit my Cub??

Posted: Tue Apr 23, 2013 8:22 pm
by Barnyard
Yes it will bolt right on, of course that depends on where you want to bolt it.

Or you can send your Cub to Rick Prentice and have him bolt in an International Scout 401 engine to mount it on. Then you would have an experimental Cub Scout.

Re: Will this fit my Cub??

Posted: Tue Apr 23, 2013 8:58 pm
by Rudi
Barnyard wrote:Then you would have an experimental Cub Scout.


:bellylaugh:

Good one Bill :D

Re: Will this fit my Cub??

Posted: Tue Apr 23, 2013 9:01 pm
by Bill Hudson
Add a locator beacon with telemetric transducer and you will have the ultimate Cub Locator. :lol: :lol:

Bill

Re: Will this fit my Cub??

Posted: Wed Apr 24, 2013 8:33 am
by Smokeycub
Barnyard wrote:Then you would have an experimental Cub Scout
Bill Hudson wrote:Add a locator beacon with telemetric transducer and you will have the ultimate Cub Locator

You guys are a hoot, made me laugh out loud! :D

On a semi-serious note Rick, I think that that would be one heck of a project. You seem to have no problem fab'ing things together and rather well I might add. A turbo on a Cub would probably double the power at the crank (what is the hp on a Cub at the crank? 13-15hp?) and increase the lower rpm torque. The low compression on the C60 (you'd need one with aluminum pistons) lends itself nicely to a turbo and you could still use a carburetor (richened up a bit) ala a Paxton supercharger. Hey, they run alcohol in Kolher motors, so why not? Granted the bottom end on the Kohlers are beefed up but if you keep the boost to say 5 lbs and a rev limiter(lol) if you run a distributor, it might work out pretty well. Would have to add an electric water pump though. Do you have a spare Cub? My son has a turbo charged, direct injected 2.4 - 4 banger that puts out nearly 300 hp. :shock:

Re: Will this fit my Cub??

Posted: Wed Apr 24, 2013 11:07 am
by Denny Clayton
I bet George Willer could have made it fit. Just a project he never got around to. 8)

Re: Will this fit my Cub??

Posted: Wed Apr 24, 2013 4:24 pm
by pickerandsinger
My brother in law designed and built props for Star Trek....He's also a red neck gear head...He has a Harley (engine only) sitting in his garage....He has a Farmall A....I once told him that engine would look good in your A or my cub....He just smiled mischievously...He mentions it on ocassion.....I'll bet you and he would get along real fine.. :bellylaugh: Dave

Re: Will this fit my Cub??

Posted: Wed Apr 24, 2013 6:29 pm
by Jim Becker

Re: Will this fit my Cub??

Posted: Fri Apr 26, 2013 6:13 am
by pickerandsinger
Not trying to hi jack your post Rick, but Mr Becker you've made my day... :applause: :bellylaugh: Dave