Good News and Bad News I guess:
After an afternoon of adjusting, I got all 3 fingers where they need to be and adjusted the clutch pedal as well. While it's a little better, the grinding is still there I'm I'm not totally sure why.....the TOB seems to have a lot of meat left on it, fingers are adjusted, pedal is adjusted and when I pull the pedal by hand, I can clearly see the TOB pushing against the fingers and the pressure plate being pulled back taking the pressure off of the disk.
The only thing that doesn't look quite right to me is all of the knicks in the TOB. When I start the engine up and proceed to push the clutch pedal in, I can hear and feel the clutch chatter,but then when I continue to push the pedal further, the chatter goes away. When looking from the bottom, I can tell that the TOB isn't quite centered on the fingers as Rick advised to look for....by hand, I can move the TOB hanger both ways slightly. Is there a way / how can I tighten up the hanger? Is there a way to tighten the hanger from the bottom through the inspection hole?
Although, the adjusting today didn't result as well as I was hoping, it was a beautiful day outside today and still felt great to take Lydia for a ride around the block.