Page 1 of 1
Hydraulic Block repair question
Posted: Tue Apr 30, 2013 7:41 am
by Papa's Cub
Is there suppose to be an o-ring on the safety relief? Also, there are 3 blue o-rings in the kit I haven't found a place for...yet. Am I suppose to use any type sealant under the head gasket? Thanks for the help.
Re: Hydraulic Block repair question
Posted: Tue Apr 30, 2013 8:42 am
by tmays
The three blue orings are not used. I do not use sealant on the gasket. You do not want sealant squeezing out and getting into the system.
Re: Hydraulic Block repair question
Posted: Tue Apr 30, 2013 9:28 am
by Matt Kirsch
Blue orings are for the hydraulic lines connection at the hydraulic pump.
Re: Hydraulic Block repair question
Posted: Tue Apr 30, 2013 10:52 am
by Stanton
Papa's Cub wrote:Is there suppose to be an o-ring on the safety relief?
Go to the "Manuals" section on the link (above right) and open the Blue Ribbon Touch Control manual. It'll have an exploded diagram of a T/C unit with index. Each seal (o-ring) is shown and labeled.