Hydraulic Block repair question

Tue Apr 30, 2013 7:41 am

Is there suppose to be an o-ring on the safety relief? Also, there are 3 blue o-rings in the kit I haven't found a place for...yet. Am I suppose to use any type sealant under the head gasket? Thanks for the help.

Re: Hydraulic Block repair question

Tue Apr 30, 2013 8:42 am

The three blue orings are not used. I do not use sealant on the gasket. You do not want sealant squeezing out and getting into the system.

Re: Hydraulic Block repair question

Tue Apr 30, 2013 9:28 am

Blue orings are for the hydraulic lines connection at the hydraulic pump.

Re: Hydraulic Block repair question

Tue Apr 30, 2013 10:52 am

Papa's Cub wrote:Is there suppose to be an o-ring on the safety relief?


Go to the "Manuals" section on the link (above right) and open the Blue Ribbon Touch Control manual. It'll have an exploded diagram of a T/C unit with index. Each seal (o-ring) is shown and labeled.