Farmall Cub

I have been wondering why these lift rods/springs for my cultivators are different. Are they even for a cub? I have never seen another set like them. The lift bracket for the rear tool bar is mounted upside down and the 90 degree bend goes into the hole and is secured with a cotter pin. Please help identify what I have here... Thanks.

Jeff

they are different, the tool bars do not look like they are for a cub either

The tool bars are off a cub

Tim,

These tool bars came off one of my cubs. I did notice the different mainly when Boss listed his for sale. However, I have never seen these lift rods. Have you or boss ever had a set? Thanks for the help.

C maybe

What is the part number in the second picture?

What's strange is that they within 1/2" length as the traditional cub. These are 22-1/2" and do not seem to ever been tampered with based on my observation. My standard ones are 22".

Jeff

Jim,

The part number is 1771 B. Thank you for the help.

Jeff

not A c or SA

I may be able to find out at work tomorrow if I have time, working at the old IH dealership

jlmason81 wrote:Jim,

The part number is 1771 B. Thank you for the help.

Jeff

I was afraid you'd say that. That was the way I read it and I had already struck out with that number.

Unfortunately that is the only number on any of the parts. I sure hope between the members on this forum we can figure if they are truly for a cub.