Farmall Cub Forum -- Questions and answers to all of your Cub related issues.
Moderator: Team Cub
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds or one of our site sponsors for your tractor and parts needs.
11 posts • Page 1 of 1
Tractor Has been restored Parked it about a year ago was running fine at the time . I cleaned out the fuel tank , carburetor put a new battery in it started it up but the oil pressure gauge says no oil pressure. un screwed oil pressure gauge and no oil came out of when I started it again , but the oil pan is full What could be wrong ????
Your oil pump has lost its prime. Check this thread for procedure/discussion of that problem.
I still wonder why this happens to some cubs. I have had a dozen or so running cubs. Some bought that had been sitting for a few years to the most of one sitting 12 years. Do the basics, clean carb, new plug, points, ect and all have started up and had oil pressure. I just wonder why some will lose the prime?
Ditto to what Jim said. There are lots of resources available to our members, suggest you follow the links below:
double check your level, my dipstick is bent like a leaf spring and reads wrong if poked in upside down. it will show level when there is only a trace of oil in my cub and can be misleading.
I suspect that this will forever remain a mystery, like the two holes in the floor plate. When I rebuilt my engine, I didn't know enough to prime the pump, but I got oil pressure anyway. Then, for some unknown reason, my cub lost prime two weeks running last summer (I was using her at least once a week to mow). However, I haven't had a problem since, even during the winter, when she may go a month or more between snowstorms. Go figure.
Eddie - a 1959 International Lo-Boy named after my father in law, who who bought her new.
Welcome from another show me resident. You're only a couple hours drive from Cuba-rama in September and even closer to a few minifests. Glad the oil pressure issue got resolved, do keep an eye on the oil pressure gauge EVERY time you start it.
A Cub fest will be held in California, Missouri, May 18, 2013. You are about 1 hours drive from California, Mo.
Very knowledgeable Cub folks will be there. Link to the Cub fest follows.
I have an excuse. CRS.
I had my '48 Cub sitting for a couple of years. When I started it this year, it was really knocking and pressure gauge was not registering pressure. I double checked with another gauge and found zero pressure. I had changed the oil and filter already. I started checking this site for answers and found this thread. I just am posting here to thank you for being so helpful to us folk. I have a repair manual...but it didn't tell me about priming. I found the priming plug, removed the oil lines from in front of it so that I could get the plug out without wrecking it. Primed up the pump and started it up and within 15 seconds had 30 psi. You folks really saved me.
G'day to you and glad you were able to solve your issues through a little research on the forums. I guess you already have a good idea of the resources we have available to our members. There are more .. suggest following the links below :
Do enjoy your Cub and remember
11 posts • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 5 guests