Tue May 14, 2013 10:52 am
I want to replace a sickle mower flywheel shaft bushing. Any advice on removing the old one and installing the new one? I tried tapping the old one out and it does not want to move. It makes me wonder how hard it will be to tap in a new one. Thanks, Lee
Tue May 14, 2013 9:09 pm
Lee, I used a long piece of 1/2" or so pipe coming through from the opposite end driving the old one out. If I remember right the new replacement bushing was split and easy to install. It also cost a little over $40.oo from a IH Case dealer.
Wed May 15, 2013 7:38 am
TM used to sell them he may have some left I know they aren't on his website anymore but they were cheap back in the day.