Okay so I'm at this point with my restoration, About half the parts are out of the el tank and primed. I figured I would change the fluids and whatever gaskets/seals I can at this point. I was thinking of doing new brakes also, I imagine they're about like everything else on this machine, run hard put away wet and run hard again. So my question is, (It's in neutral and wheels are off) when I turn the hubs by hand they rotate fine but it's not the smoothest sound. I drained the oil from the finals and pulled the cover on the rear where the pto is (not sure what it's called) I found a little water and sludge but no metal. Is there anything I should look for or check at this point? Suggestions are greatly appreciated
And no comment on the shop haha..
You do not have the required permissions to view the files attached to this post.