cub tranny and creeper

Tue May 28, 2013 10:26 am

do you guys think this is the same tranny used on farmall cubs and low range reducer?

http://classifieds.pennswoods.net/class ... ex=2296182

Re: cub tranny and creeper

Tue May 28, 2013 10:36 am

Trans in the same. If you plan to use the trans in a Cub, just have to flip the punkin, otherwise you will have three reverse gears and one forward. The Hi-Lo will not work in a Cub.

Bill

Re: cub tranny and creeper

Tue May 28, 2013 11:05 am

Cadet only,with he hi-lo. As Bill said, can be used in a cub, with the Hi-Lo, removed, and the cub shaft added. Need a cap, on the lower shaft bearing, too, for use in a cub, as well as flipping the differential gears, as Bill mentioned. Ed

Re: cub tranny and creeper

Tue May 28, 2013 1:46 pm

Image

Looking at that picture, it appears that the holes for the rockshaft mount on the top of the transmission are either filled with cork or not drilled/tapped, also I can't tell whether the hole for the PTO on the side of the tranny is drilled and filled with a Welch plug if it is not drilled. The holes to mount the floor pan look like they are not drilled/tapped either.

Gears and bearings would work for a cub, though. (except the parts that the guys mentioned before)...

Mike

Re: cub tranny and creeper

Tue May 28, 2013 3:57 pm

that rear is not off a original its not the same