Brake pedal

Tue May 28, 2013 2:57 pm

How do you remove the left brake pedal? I need to remove the
platform for refinishing, sandblasting & paint. Do I have to press
out the long shaft, if so will this do anything to the clutch assembly?
Replacing the transmission oil seals and figured it time to do the
shaft housing & platform.
Could not fine info in my manual.

Re: Brake pedal

Tue May 28, 2013 3:48 pm

to remove the left pedal,yes the shaft has to come out, the hard part is most of the time that the pedal is seized to the shaft, some times they fall off, other times you need explosives
Tim

Re: Brake pedal

Tue May 28, 2013 5:01 pm

I belive there is a how to by Ralph, and he has done a lot of them.

check how to forum

Re: Brake pedal

Thu May 30, 2013 9:28 pm

IMG_7110x.jpg
IMG_7108x.jpg
Thanks for your help, mission accomplished. Made a puller from a piece
of 2- 3/8" sq. tubing. Cut 3/4" slot and welded the piece on top. Drilled
and taped 1/2-20 NF. Had kroil oil in peddle for 24 hours and used puller
the brake peddle cam off easily.
You do not have the required permissions to view the files attached to this post.

Re: Brake pedal

Thu May 30, 2013 11:30 pm

I had to heat the heck out of it plus drill out the bolt.. It was the most difficult froze up thing I have taken apart on my Cub so far. I would heat it then quench with Sea Foam and heat again.

Good luck....Heat heat heat...

Re: Brake pedal

Fri May 31, 2013 11:45 am

Excellent solution. Beating on the shaft with a punch is a death knell as it is soft and mushrooms easily. looks like a "tip of the week" to me.

Re: Brake pedal

Fri May 31, 2013 6:28 pm

All done Bob....

I saw it earlier and if I had been less winded, it would have been up earlier.

Cub Tip of the Week! May 31, 2013

Excellent solution Dick, I like that - using what you have to git-r-done :big smile:

Re: Brake pedal

Fri May 31, 2013 7:53 pm

Well, sure wish this post had been here before I went throught the antics I did with the press. I kroiled mine for 10 days and it still took a full 20 tons of pressure under heat before mine popped 1/64".

Thanks for sharing.

Re: Brake pedal

Fri May 31, 2013 8:16 pm

I also have a puller/press like the one above and have had some it will not even budge after being heated many times