Thu Jun 27, 2013 6:22 pm
When the clutch is reinstalled onto the flywheel is there a specific tension of the springs, or is the tension simply set when the clutch and flywheel are tight together?
I will need to reinstall the fingers onto the clutch plate. Can I just hold the pieces together with C-clamps (compressing the springs) when I put the pivot pin for the fingers back in, or is the tension more precise?
I hope my question is clear.
Thu Jun 27, 2013 9:42 pm
If it's only the finger spring you may not need any devices to compress the spring.
Never had a pressure plate apart, so don't really know the answer. Suggest looking at the service manual.
Pressure plate springs are tested be for installation in to the pressure plate.
Powered by phpBB © phpBB Group.
phpBB Mobile / SEO by Artodia.