How much side-to-side free play should be present when replacing the TOB on the pin that goes through the bell housing? I have about 3/8 inch which can allow the TOB to be slightly off center. I'm wondering if I need a washer/spacer on each end of the pin to keep the TOB assembly centered.
Thanks,
Todd
throw out bearing replacement
Moderator: Team Cub
Forum rules
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds or one of our site sponsors for your tractor and parts needs.
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds or one of our site sponsors for your tractor and parts needs.
-
TJG
- 5+ Years
- Posts: 1224
- Joined: Wed Jul 02, 2008 6:11 am
- Location: MN, Mankato
-
- Similar Topics
- Replies
- Views
- Last post
-
- 22
- 853
-
by Jim Becker
Mon Aug 31, 2015 6:32 pm
-
- 5
- 208
-
by brewzalot
Mon May 23, 2016 10:02 pm
-
- 6
- 370
-
by Bhaeck
Wed Sep 30, 2015 7:25 pm
-
- 2
- 225
-
by Eugene
Wed Nov 11, 2015 2:46 pm
-
-
New Automotive type vs Graphite Throw out Bearing Attachment(s)
by PoconoCub » Wed Oct 08, 2014 11:45 am » in Farmall Cub - 19
- 984
-
by Scrivet
Thu Oct 09, 2014 10:03 pm
-
Who is online
Users browsing this forum: No registered users and 3 guests
