Touch Control Friction Disc

Sat Jul 06, 2013 6:37 pm

Anyone here know of a source (or suitable substitute) for the friction disc (IH Part No. 350 912 R 1) that fits between the control lever and the control lever bracket? Mine is long since missing, and the control lever won't stay put in mid-range. This is not normally a problem, as I only run a CUB-22 mower and it is usually either fully raised or lowered, but I would like for the control to work more like it is supposed to than it does now.

Jim

Re: Touch Control Friction Disc

Sat Jul 06, 2013 9:15 pm

if it is the one with the adjustable friction, it is still available form Case IH, but if it is the one you cannot adjust the friction on, you will have to look around. I found a disk at a lawnmower repair shop for the lever disk on a hydrostat that worked out pretty good, unfortunately it has been so long ago I do not remember what mower, or even brand it was for.

Re: Touch Control Friction Disc

Sun Jul 07, 2013 1:47 am

Yes, unfortunately mine is the older non-adjustable. Will check around the local lawnmower shops and see what I can turn up.
Thanks, that's more than I had to go on.

Jim

Re: Touch Control Friction Disc

Sun Jul 07, 2013 9:41 am

forgot to mention, the one I found was a smaller diameter, but it worked.