Wed Jul 17, 2013 5:55 pm
Hi guys, on the points for Cubs, where should the rub block be, towards the pivot or the point end? I've seen them both ways and wondering if they are interchancable or did the change sometime during the run. I have a 49, 53, and a 57, just want to get right ones when it's tune-up time. I did some searching but could not find any info on them. Thanks for any answers and all. Bill wlm cub
Wed Jul 17, 2013 7:25 pm
They made a run of bad parts a couple years ago. IH original equipment, too. ooops!
Fri Jul 19, 2013 9:47 am
bob in CT wrote:They made a run of bad parts a couple years ago. IH original equipment, too. ooops!
Thanks bob in CT, for the info. wlm cub