Re: Changing Points & Condenser

Tue Aug 13, 2013 8:15 pm

If you take the distributor out, your mouth can be sucking on a coffee, while you easily install the screws! Ed

Re: Changing Points & Condenser

Tue Aug 13, 2013 8:19 pm

TomE wrote:I use a combination of a short screw driver and have found a certain way to hold my mouth that makes for an easier job.

You probably have a stubby, but will have to do a lot of research to discover a good mouth position. It is different for everyone.


I'd also like you to leave my stubby out this conversation please. :big smile: :spinning:

Re: Changing Points & Condenser

Tue Aug 13, 2013 8:25 pm

PVF1799 wrote:
TomE wrote:I use a combination of a short screw driver and have found a certain way to hold my mouth that makes for an easier job.

You probably have a stubby, but will have to do a lot of research to discover a good mouth position. It is different for everyone.


I'd also like you to leave my stubby out this conversation please. :big smile: :spinning:

:lol: :lol: :bellylaugh: :bellylaugh:

Re: Changing Points & Condenser

Tue Aug 13, 2013 8:52 pm

Just out of curiosity, out of all the guys who said it was easy to change the points and condenser with the distributor on the tractor, how many are left handed??? Image

Re: Changing Points & Condenser

Tue Aug 13, 2013 8:59 pm

ricky racer wrote:Just out of curiosity, out of all the guys who said it was easy to change the points and condenser with the distributor on the tractor, how many are left handed??? Image


You betcha. I'm left handed but, for the record, I didn't say it was easy to change the points and condenser on the tractor. :) :)

Bill

Re: Changing Points & Condenser

Tue Aug 13, 2013 9:23 pm

ricky racer wrote:Just out of curiosity, out of all the guys who said it was easy to change the points and condenser with the distributor on the tractor, how many are left handed??? Image


Dont know but do know that they have never changed em with it out :lol: :lol:

Re: Changing Points & Condenser

Wed Aug 14, 2013 8:24 am

much easier with dist out and like ya said,Boss ya need to ck timing anyway and hope the gap is correct

Re: Changing Points & Condenser

Thu Aug 15, 2013 8:16 pm

I will clean points and adjust them with the dist. mounted. I remove points to dress them, but this weekend will be new points and condenser and I'll pull the dist. for sure.