Help getting blade on cub

Mon Sep 16, 2013 5:58 pm

Just got a 1955 cub with a woods mower pickup a #54 blade most fittings were there but missing part number 651237 R need two anyone have extras? or know where we can purchase them?

vern b

Re: Help getting blade on cub

Mon Sep 16, 2013 6:18 pm

If you are talking about the spacers, just make some from square stock (1 1/2 inch square with 5/8ths hole.

Re: Help getting blade on cub

Mon Sep 16, 2013 6:31 pm

TM has them, if you can't make them. http://www.tmtractor.com/new/gb/393fp.htm

Re: Help getting blade on cub

Mon Sep 16, 2013 8:00 pm

I thought I was missing one of those too, but I found it when I put on my cultivators - it was stuck in the middle of the casting where i couldn't see it!

Re: Help getting blade on cub

Mon Sep 16, 2013 8:09 pm

Thanks barnyard I just order two one would have to buy 12 feet of material just for a few inches.

Re: Help getting blade on cub

Mon Sep 16, 2013 8:20 pm

You went to the wrong store, I can buy local by the foot. 12 ft., that's three toolbars!

Re: Help getting blade on cub

Mon Sep 16, 2013 8:40 pm

I was quoteing from my supplier for the machine shop.

Re: Help getting blade on cub

Mon Sep 16, 2013 8:49 pm

My welder will sell me any length I want if he has it on hand. Sometimes a short piece is scrap to him.

Re: Help getting blade on cub

Mon Sep 16, 2013 9:15 pm

thanks Barnyard Tought of useing the lost form casting to make what I needed has any one done this?

Re: Help getting blade on cub

Mon Sep 16, 2013 9:19 pm

Vern, Unless you do sand casting yourself, I'll think you'll find it is far more expensive to have them cast than to buy them or make them out of stock.

Bob