Mon Sep 16, 2013 5:58 pm
Just got a 1955 cub with a woods mower pickup a #54 blade most fittings were there but missing part number 651237 R need two anyone have extras? or know where we can purchase them?
Mon Sep 16, 2013 6:18 pm
If you are talking about the spacers, just make some from square stock (1 1/2 inch square with 5/8ths hole.
Mon Sep 16, 2013 8:00 pm
I thought I was missing one of those too, but I found it when I put on my cultivators - it was stuck in the middle of the casting where i couldn't see it!
Mon Sep 16, 2013 8:09 pm
Thanks barnyard I just order two one would have to buy 12 feet of material just for a few inches.
Mon Sep 16, 2013 8:20 pm
You went to the wrong store, I can buy local by the foot. 12 ft., that's three toolbars!
Mon Sep 16, 2013 8:40 pm
I was quoteing from my supplier for the machine shop.
Mon Sep 16, 2013 8:49 pm
My welder will sell me any length I want if he has it on hand. Sometimes a short piece is scrap to him.
Mon Sep 16, 2013 9:15 pm
thanks Barnyard Tought of useing the lost form casting to make what I needed has any one done this?
Mon Sep 16, 2013 9:19 pm
Vern, Unless you do sand casting yourself, I'll think you'll find it is far more expensive to have them cast than to buy them or make them out of stock.
Powered by phpBB © phpBB Group.
phpBB Mobile / SEO by Artodia.