Sun Sep 22, 2013 9:43 am
We went out for a drive in the country yesterday and stopped to look at a cub for sale. The spare set of wheels look like they were ready for a Halloween festival; not sure how they ended up this color but the price was right and they fit in the back of the truck. They are original and make for a good first project in the electrolysis tank (thank you Rudy for the tons of info on that process).
ps you may also notice that a dryer drum can be re-purposed to an IH table (not complete yet). We could use it for a planter, table with cooler / bar inside) time will tell.
You do not have the required permissions to view the files attached to this post.
Sun Sep 22, 2013 10:37 am
Sun Sep 22, 2013 10:44 am
Thanks David. It doesn't hold a candle to that trailer full of goodies you found.
Sun Sep 22, 2013 12:24 pm
Those wheels and tires may have come from a Power King tractor. Certain models used the exact same front and rear wheels as a Cub. Power Kings were orange and black at one time.
Sun Sep 22, 2013 1:14 pm
Good grab Dave, are you sure the seller wasn't a Bengals fan? You weren't traveling around Ralph's and my part of the country were you?
Sun Sep 22, 2013 1:39 pm
Thanks for the info Matt.
Bill, The area we were in might have been more prone to a black and yellow set.
Then again, based on how our team is doing there are no plans for a Browns cub either
Sun Sep 22, 2013 3:39 pm
Very nice snag
... those are nice lookin tires and rims. Centres ain't too shabby either - nothin the tank won't fix
Tue Sep 24, 2013 3:10 pm
Dave, I agree with Matt, those wheels and tires probably came off a Power King. I bought a power king awhile back that had a nice set of tires and rims. After a good cleanup and a little IH red and white paint and those wheels now reside on my Cub. The Cub tires and rims are proudly sported by the Power King. You can't tell the difference between the two different sets.
Fri Sep 27, 2013 8:30 pm
Thanks for the feedback Rudi & Roy.
Has anyone performed electrolosys on the rear centers and rear rims here?
The rear centers are stampings right?
Anybody worry about hydrogen embrittlement?
Fri Sep 27, 2013 9:32 pm
I haven't done the rims but definitely the centers. We did those at CubFest Northeast 2006 as one of the demonstrations.
Hydrogen embrittlement? In a little electrolysis tank? Not likely. At times this procedure gets overthunk. Pretty simple and straightforward.
Powered by phpBB © phpBB Group.
phpBB Mobile / SEO by Artodia.