Farmall Cub

by **Don McCombs** » Wed Nov 20, 2013 10:19 am

Wasn't someone looking for one of these?

http://www.ebay.com/itm/PTO-Shaft-IH-In ... 415ff9f3f0

by **Gerry Powell** » Wed Nov 20, 2013 1:11 pm

I'm looking but not sure about the replacement shafts as compared to the originals. I'm pretty sure the old IH parts were induction heat treated in the spline areas to make them durable. I'm sure it fits, but what makes me hesitate is the way the new parts may not be heat treated in the wear areas. Does anyone have experience with aftermarket shafts?
Gerry

by **J Dubya** » Wed Nov 20, 2013 4:06 pm

That would be me! Thanks for the heads up Don I just went and got it. Figure worth a shot for $22 and free shipping!

by **Don McCombs** » Wed Nov 20, 2013 4:32 pm

J,

Let us know what you think after receiving it.

by **tst** » Wed Nov 20, 2013 5:43 pm

I bought one 2 weeks ago and found I had to remachine the groove for the snap ring, other than that it was ok
Tim

by **Don McCombs** » Wed Nov 20, 2013 7:51 pm

I've had some off-line reports that the quality on these shafts may not be up to par. Particularly the shaft diameter where the bearing goes may be a little small. So, as with anything, buyer beware.

by **Scrivet** » Thu Nov 21, 2013 8:29 pm

Isn't this the same thing? From one of our site sponsors? $0.99 cheaper?

http://www.ebay.com/itm/NEW-PTO-SHAFT-11-1-2-FITS-IH-INTERNATIONAL-FARMALL-CUB-LOBOY-/350926061896?pt=BI_Heavy_Equipment_Parts&hash=item51b4d2c148

Farmall Cub

PTO Shaft

PTO Shaft

Share On:

Re: PTO Shaft

Re: PTO Shaft

Re: PTO Shaft

Re: PTO Shaft

Re: PTO Shaft

Re: PTO Shaft

Who is online