1000 loader return hose length

Fri Feb 28, 2014 7:27 pm

Could one of you that has a 1000 loader measure the length of the low pressure return hose? I believe it is 3/4" ID, but can't find a length in the manual or parts description.

Thanks, Bob

Re: 1000 loader return hose length

Sat Mar 01, 2014 7:22 am

Bob...It looks like Messicks has the lengths on the "E-08" diagram.
http://www.messicks.com/CAS/56567.aspx

Re: 1000 loader return hose length

Sat Mar 01, 2014 9:36 am

Dave, It shows the lengths for the pressure lines but not for the "sump" hose which is what I need. Thanks for looking.

Bob

Re: 1000 loader return hose length

Sat Mar 01, 2014 10:33 am

Bob, I got the measurements we talked about on the phone. Under the Cub like mine (owner mod perhaps) the hose is 48". Over the hood looks like it would be about 36". I measured from the touch control on the Cub to the bottom fitting on the loader reservoir. That 48" measurement includes the mess of fittings that have been added on mine that you probably don't need.

Here is how it is run on mine.
loaderhose.jpg


Here is that mess of fittings I mentioned.
[
loaderfitting.jpg
You do not have the required permissions to view the files attached to this post.

Re: 1000 loader return hose length

Sat Mar 01, 2014 11:22 am

Bob, on the below installation I used a 3 footer. That was what the old one was. It has been on a Cub, Lo-Boy and now a 140 and it works fine.

Image

Re: 1000 loader return hose length

Sat Mar 01, 2014 11:24 am

Thanks Bill and Denny.

Bob