Hi Folks
I have progressed to stripping down my final drives so I can get all the seals ordered from TM as they take a few weeks to get over here to Scotland.
My first question today is: should there not be a cap on both sides of the bottom output shafts on the inside? Please refer to my photograph (left hand one in my hand is off the near-side / right hand side one is off the off-side but there is not a cap (there is a mount) this seems strange to me? has it been got at?
Regards
Ian
This site uses cookies to maintain login information on FarmallCub.Com. Click the X in the banner upper right corner to close this notice. For more information on our privacy policy, visit this link: Privacy Policy
NEW REGISTERED MEMBERS: Be sure to check your SPAM/JUNK folders for the activation email.
Final drive cap
Forum rules
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds or one of our site sponsors for your tractor and parts needs.
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds or one of our site sponsors for your tractor and parts needs.
-
- 10+ Years
- Posts: 118
- Joined: Sat Jan 04, 2014 12:25 pm
- Zip Code: 00000
- Location: Scotland, UK
- Bill V in Md
- 10+ Years
- Posts: 1109
- Joined: Sun Feb 02, 2003 6:51 pm
- Zip Code: 21228
- Tractors Owned: 1948 Farmall Cub
LT1045 Cub Cadet - Circle of Safety: Y
- Location: MD, Catonsville
- Contact:
Re: Final drive cap
Ian,
The final in your photo, which is on the right side, is left open without a cap to facilitate attachment of a drive sprocket for the planter.
The final in your photo, which is on the right side, is left open without a cap to facilitate attachment of a drive sprocket for the planter.
Bill VanHooser
Cub 54 Blade, Cub 193 Moldboard Plow, Cub 28A Disc Harrow
Cub 54 Blade, Cub 193 Moldboard Plow, Cub 28A Disc Harrow
-
- 10+ Years
- Posts: 118
- Joined: Sat Jan 04, 2014 12:25 pm
- Zip Code: 00000
- Location: Scotland, UK
Re: Final drive cap
Hi Bill
Great - thanks for the info, much appreciated
Regards
Ian
Great - thanks for the info, much appreciated
Regards
Ian
Who is online
Users browsing this forum: No registered users and 25 guests