So much for my confidence that the frame was not bent.
Bill
This site uses cookies to maintain login information on FarmallCub.Com. Click the X in the banner upper right corner to close this notice. For more information on our privacy policy, visit this link: Privacy Policy
NEW REGISTERED MEMBERS: Be sure to check your SPAM/JUNK folders for the activation email.
grader blade and wierd angle problem
Forum rules
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds or one of our site sponsors for your tractor and parts needs.
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds or one of our site sponsors for your tractor and parts needs.
- Bill Hudson
- Team Cub
- Posts: 9513
- Joined: Wed Jul 26, 2006 10:50 am
- Zip Code: 44057
- Tractors Owned: 57 F-Cub - Dad & Mom's Cub
77 F-Cub - Red Long Stripe - Circle of Safety: Y
- Location: OH, Madison
-
- 5+ Years
- Posts: 30
- Joined: Sat Jun 20, 2015 2:43 pm
- Zip Code: 52202
Re: grader blade and wierd angle problem
no worries, i would blame the picture taker
Learning about and fixing grampa's old tractor one post at a time
-
- 5+ Years
- Posts: 30
- Joined: Sat Jun 20, 2015 2:43 pm
- Zip Code: 52202
Re: grader blade and wierd angle problem
Well i thought an update was in order. I have been dismantling the grader blade, getting new bolts. i have sand blasted a few parts and used some good old fashioned rattlecan paint. It wont be the prettiest blade at the ball, but it will be a little nicer looking.
The biggest updates are to the new "pin" i made out of stainless. that should be good now for as long as i am around. it wasnt bad part to make, having a drill press helped alot.
The frame was a bit beyond my current capabilities and i enlisted the help of my father-in-law. He is a semi-retired millwright and still has access to a large industrial shop where he works part time. he took my old bent frame and used it as a template. I think the picture below speaks for itself.
I also acquired a new cutting edge from a local case-ih dealer.
The biggest updates are to the new "pin" i made out of stainless. that should be good now for as long as i am around. it wasnt bad part to make, having a drill press helped alot.
The frame was a bit beyond my current capabilities and i enlisted the help of my father-in-law. He is a semi-retired millwright and still has access to a large industrial shop where he works part time. he took my old bent frame and used it as a template. I think the picture below speaks for itself.
I also acquired a new cutting edge from a local case-ih dealer.
Learning about and fixing grampa's old tractor one post at a time
Who is online
Users browsing this forum: Crimson Tim and 28 guests