This site uses cookies to maintain login information on FarmallCub.Com. Click the X in the banner upper right corner to close this notice. For more information on our privacy policy, visit this link: Privacy Policy
NEW REGISTERED MEMBERS: Be sure to check your SPAM/JUNK folders for the activation email.
cub carburetor
Forum rules
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds or one of our site sponsors for your tractor and parts needs.
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds or one of our site sponsors for your tractor and parts needs.
-
- 10+ Years
- Posts: 86
- Joined: Fri Dec 06, 2013 4:53 pm
- Zip Code: 00000
cub carburetor
I know several on here fix and repair cub carbs.Anyone in Canada? Should be less shipping and chance of border problems it it stays in one country.thanks
-
- 5+ Years
- Posts: 11
- Joined: Fri Oct 28, 2016 7:34 am
- Zip Code: L3B5N4
- Tractors Owned: 1959 Cub
1949 Cub - Location: Ontario, Canada
Re: cub carburetor
I live in Ontario Canada and in the process of a carb repair, what type of repairs are you after?
A basic kit install or is the idle tube broken or missing, warped top, etc.
A basic kit install or is the idle tube broken or missing, warped top, etc.
-
- 10+ Years
- Posts: 86
- Joined: Fri Dec 06, 2013 4:53 pm
- Zip Code: 00000
Re: cub carburetor
I think I have one of everything you said
-
- 5+ Years
- Posts: 11
- Joined: Fri Oct 28, 2016 7:34 am
- Zip Code: L3B5N4
- Tractors Owned: 1959 Cub
1949 Cub - Location: Ontario, Canada
Re: cub carburetor
Well I am going to attempt drilling and tapping the hole in my carb top for the new idle tube.
This will be my first try at this task, if I succeed I may offer to do yours for you if you like.
I have drilled out the broken idle tube from the base of my carb and all went well.
I have new idle tubes.
I do have the 3/32 left drill and 4-48 nf tap required.
As far as the warped top I have repaired that in the past.
Have you purchased a new kit yet?
Was your carb in use or has it been sitting around for a long time?
What part of Canada are you from?
This will be my first try at this task, if I succeed I may offer to do yours for you if you like.
I have drilled out the broken idle tube from the base of my carb and all went well.
I have new idle tubes.
I do have the 3/32 left drill and 4-48 nf tap required.
As far as the warped top I have repaired that in the past.
Have you purchased a new kit yet?
Was your carb in use or has it been sitting around for a long time?
What part of Canada are you from?
Who is online
Users browsing this forum: cdahl383, Crimson Tim and 24 guests