Replacement front crank seal

Time saving tips to keep your Cub running smooth

Moderators: Barnyard, Team Cub

Replacement front crank seal

Postby Ralph » Sun Aug 31, 2008 7:43 pm

assuming the necessary steps have been taken to remove the crankshaft pulley we will begin with the seal in the front engine cover.

Removing the seal can be done many different ways.................
if you have a seal puller they work verry well
it can be removed by using a small chisel to dent the sise in and pry it out with a screw driver
or you can make a seal puller by putting a sharp 90 degree bend on the end of a small peice of steel stock to pull it out.
if you have the front cover removed just knock it out fron the inside

Image

clean the opening lube the opening for the new seal set the seal in place and tap it it in evenly

Image

most of the crank pulleys have a worn groove in them where the old seal was riding so when ordering the seal get the one with the sleeve.
here the sleeve is set in place to be installed

Image

and here we have a Master press operator applying the correct amount of pressure to push the sleeve on with out damaging it.
Image

here we have the new wear sleeve installed and ready for installing the pulley back on the engine

Image

The sleeve installation tool is another one of the excellant products of Bill poore and his friend EArl the Machinist.
Shoot low Sherriff they are Riding Shadows
4 Wheels move the body.....
2 Wheels move the Soul .....

Shop Phone 859-283-2668
Ralph in ky.
User avatar
Ralph
Cub Pro
Cub Pro
 
Posts: 2665
Joined: Sun Feb 02, 2003 7:01 pm
Location: Ky Florence Y'ALL
Zip Code: 41005
Tractors Owned: Near 200 cubs through the years
Circle of Safety Award
Circle of Safety: Y

Return to Engine, Clutch, Transmission and Hydraulics

Who is online

Users browsing this forum: No registered users and 1 guest

cron