How To Make a Replacement Clutch Inspection Hole Cover

Time saving tips to keep your Cub running smooth

Moderators: Barnyard, Team Cub

How To Make a Replacement Clutch Inspection Hole Cover

Postby BIGHOSS » Fri Jan 09, 2009 6:10 pm

Clutch Hand Hole Cover

This is a simple and easy method of fabricating a hand hole cover using basic tools without the need to weld.

The cover was found in a Goodwill Store for $1.99. It was used as a base in a large candle holder.

Image

The cover diameter was 4-1/4"

Here are all of the other parts:

Image

The bill of materials is:

(1) 1/4-20 x 2" Stove Bolt
(1) 1/4 x 1" x 4-1/4" Bar Stock
(1) 1/4 x 1" x 3” Bar Stock
(1) 5/16” Flat Washer
(2) 1/4-20 Nuts
(1) SS 5/16” Flat Washer
(1) 1/4-20 Wing Nut


Drill one 1/4" hole in the center of the cover and two 1" brackets. The brackets were fastened together with bolt, flat washer and (2) hex nuts jammed to prevent coming loose. The combination of the two nuts and flat washer are the perfect thickness to act as a backup to prevent bending of the cover, when the wing nut was tightened.

This is the completed assembly:

Image Image

Since my cover was only about .030" thick, I epoxy bonded a 3-3/4" diameter doubler to the inside to add rigidity, when the wing nut is tightened. This step would not be necessary if a thicker cover was used.
We make a living by what we get, but we make a life by what we give......Winston Churchill
User avatar
BIGHOSS
5+ Years
5+ Years
 
Posts: 1296
Joined: Tue Jul 18, 2006 9:55 pm
Location: TN, Lebanon
Zip Code: 37087
Tractors Owned: 1947 Cub S/N 9216
1974 Cub S/N 244814
w/ C-22 Mower

Ford 3000 Gas S/N C375091 w/Bushhog QT2345 Loader & 6' Squealer Bushhog
Circle of Safety Award
Circle of Safety: Y

Return to Engine, Clutch, Transmission and Hydraulics

Who is online

Users browsing this forum: No registered users and 0 guests