Head Bolt Drill Guide

Time saving tips to keep your Cub running smooth

Moderators: Barnyard, Team Cub

Head Bolt Drill Guide

Postby Harold R » Wed Nov 02, 2011 3:13 pm

They can sure rear their ugly heads from time to time! :x

Image


Thanks to head Gremlin chaser....Dad. :lol: He can come up with some of the slickest ideas.

Nice, easy to use, easy to make...(sorta) gizmo.

Image
Image

Just grind off nub of bolt down flush to block....(or as close as you can without gouging into the block, re-install head...no gasket and just snug with enough bolts to insure alignment, place drilled dummy bolt in broken bolt hole, and drill pilot hole. We drilled just a tiny bit at a time to check alignment. Once hole was drilled, we removed head and used larger drill bits until we could flake out old threads. Worked really well.

Image

He'd rather be here than at home in the easy chair.
Image
Harold R
Team Cub Guide
Team Cub Guide
 
Posts: 3101
Joined: Thu Feb 20, 2003 4:54 pm
Location: Louisiana
Zip Code: 71058
Tractors Owned: 1948,50,53, and 56 Farmall Cubs
1969 International Cub
Circle of Safety Award
Circle of Safety: Y

Return to Engine, Clutch, Transmission and Hydraulics

Who is online

Users browsing this forum: No registered users and 2 guests