Wear Sleeve Installer

Time saving tips to keep your Cub running smooth

Moderator: Team Cub

Jdbfish
5+ Years
5+ Years
Posts: 103
Joined: Mon Nov 12, 2012 9:52 pm
Zip Code: 76502

Wear Sleeve Installer

Postby Jdbfish » Sat Jan 19, 2013 10:00 pm

Use a 1-1/2" PVC coupler fitting as shown:
fitting%201.jpg


Saw the coupler fitting lengthwise in 2 places removing a section approximately 1/4 to 2/3rds of the total circumference. This will reveal a molded step in the ID (which I marked in black for clarity) as shown:
fitting%202.jpg


Then saw the coupler fitting's overall length to approximately 1-1/2" - 1-3/4" as shown:
fitting%203.jpg


Slide the short end of the coupler fitting over the wear sleeve until the step hits the edge of the wear sleeve as shown:
fitting%204.jpg


Tighten a hose clamp around the modified coupler fitting to keep it from spreading open or moving around. Then use a wood block on top of the coupler fitting and hammer it onto the crank pulley as shown:
fitting%205.jpg


All done!
Last edited by Barnyard on Tue Mar 20, 2018 6:57 pm, edited 1 time in total.
Reason: Added Missing Images

  • Similar Topics
    Replies
    Views
    Last post

Return to “Engine, Clutch, Transmission and Hydraulics”

Who is online

Users browsing this forum: oldhammerhead and 0 guests