Switch to full style
Any other helpful tips you may have.
Post a reply

Oh well

Mon Mar 19, 2007 4:47 pm

this was last summer I just got the strenth to tell

Image

Image

Mon Mar 19, 2007 5:04 pm

Uh Steve..................................... the dirty side goes down.

Seriously, I hope no one was hurt. This just points out the necessity of those wedges between the front axle and the bolster.

Mon Mar 19, 2007 5:06 pm

I hope and pray no one was hurt :!: Cubs can be mended.
Maybe you can write a "How NOT To Jack Your Tractor :?: :?:
8)

Mon Mar 19, 2007 5:21 pm

No one got hurt was by myself. Tractor was ok ni even a broken lite.

Mon Mar 19, 2007 5:31 pm

Glad no one suffered any injuries.

Moderators: Obtain permission from the author and post the photos in:

http://www.farmallcub.com/phpBB2/viewtopic.php?t=18081

Eugene

Mon Mar 19, 2007 5:55 pm

Yep.... without the wedges they sure are tippy! How do I know that???? :oops:

Mon Mar 19, 2007 5:57 pm

Steve:

Glad you were not hurt. I think Donny has a point and it would be an asset to the How To Section... let me know what you think about it please. :idea: :?:

Mon Mar 19, 2007 6:09 pm

I think Eugene had a good idea. It should go in the indicated "How To" showing what can happen.
8)

Mon Mar 19, 2007 6:18 pm

Well that is one easy way to adjust clutch fingers. Now you can get right at the hand hole.

I had almost the same experience minus landing on the floor. :oops: :oops:

How did the cub flip over?
Did you have the rear tires off and it was leaning and than flipped over?
Did you take the right side tire off and than it flipped over?

The story could be helpful to virgin flippers and of course the experienced flippers (like my self) could get a reminder of what not to do.

Mon Mar 19, 2007 7:01 pm

I was taking wheels off had left side on jack stand with wheel off, right side on jack stand, and when i pulled that wheel off it had wheel weights on it shook the tractor and the left jack stand kicked and down it went. :shock: I don't know if wedges would have helped but I will use them from now on. :oops:

Mon Mar 19, 2007 7:32 pm

that is one way to make it easier to clean and repaint the belly of a cub!!
Ron

Mon Mar 19, 2007 9:15 pm

Steve the truth sall set you free :!: glad no one was hurt. i know it made you sick to see your cub like that :cry:

Mon Mar 19, 2007 9:32 pm

Steve,

I'm wondering how you righted the Cub :?:
8)

Tue Mar 20, 2007 4:20 am

Hey Steve...GLAD YOU'RE O.K. :!: :wink: Jack Stands Are Good, but they're NOT 100% Reliable. :!: :oops:

If your Cub's rearend was up on blocks, and the front was wedged between the bolster...I don't believe she would have flipped over :shock:

Tue Mar 20, 2007 5:51 am

Mine almost went over.I was down in the barn did not know to wedge it.I was down there holding it for fifteen mins when Tracy finally heard me.She was going to let me stay in the barn.can you belive that!!!Sorry to see your tractor sleeping on its side!Ketcham
Post a reply