Super A rod bearing question.
Posted: Sun Nov 19, 2006 8:14 am
Finally got my engine unstuck and pulled it all apart sleeves and all. Was looking at the rod bearing and they had a 030 stamped on them.Along with a lot of other numbers. This does mean these are .30 over standard doesn"t it. The cranks looks like it needs to be turned.But is not real bad. Is there any bearing over .30 or is that it. Don"t see any anywhere. What are my options on a crank? Have not looked at the main bearings yet. My crank measured out at about 1.715 at the rod bearing. Standard is about 1.750 so about .30 seems right. About what is a good price for turning a crank? or good guess