Hi,
I just started here after uncovering an unknown part on my 41 A. I took the transmission inspection cover off the front of the clutch housing and there was a triangular piece of sheet metal folded over the rivets holding it to the cover. The rivets were loose and the metal wiggles. It appaers to be something like a timing mark but it is badly bent. Any idea what it is for and how to straighten it to the correct position?
Thanks,
Dan
This site uses cookies to maintain login information on FarmallCub.Com. Click the X in the banner upper right corner to close this notice. For more information on our privacy policy, visit this link: Privacy Policy
NEW REGISTERED MEMBERS: Be sure to check your SPAM/JUNK folders for the activation email.
Unknown part
Forum rules
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds or one of our site sponsors for your tractor and parts needs.
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds or one of our site sponsors for your tractor and parts needs.
-
Daniel H.
- 10+ Years
- Posts: 613
- Joined: Mon Feb 03, 2003 1:18 pm
- Zip Code: 27055
- Tractors Owned: 1951 Super A
1955 Cub Lo-boy
1955 Ferguson TO-35 - Circle of Safety: Y
- Location: NC, Yadkinville
That is the timing pointer. Can you use a small punch to tighten the rivets? There is also a small arrow on the flywheel. You need to clean them both and apply a little white paint so that when you need to time the engine you can see them. The mark on the flywheel is hard to see. This picture is from a Super A manual, but the flywheel is the same.
The four most expensive words in tractor restoration: "We might as well..."
Return to “Farmall A, Super A, AV, 100, 130 & 140”
Who is online
Users browsing this forum: No registered users and 15 guests
