Fri Nov 09, 2007 6:29 pm
I have to replace the rear main seal in my Super A so I figure I will go ahead and replace the clutch also. Am I to optimistic to think I can split the tractor and do this in one day?
Fri Nov 09, 2007 6:48 pm
If you have no problems and some help you can
Sat Nov 10, 2007 12:58 am
Hopefully the flywheel wont need resurfacing. Check the ring gear also, might as well change it or flip it over while your there.
Dont forget the small gaskets in between the seal housing halves.
Most likely the new pressure plate will look a little different than the old one but it will work just fine.
Sat Nov 10, 2007 7:49 am
I am sure with some help it can be done
Powered by phpBB © phpBB Group.
phpBB Mobile / SEO by Artodia.