Super A in primer today, two push rods look bent?

Mon Feb 25, 2008 12:16 am

Sent a lot of time on the Super A this weekend. Finished the sand blasting and shot the primer today. Took off the valuv cover today and two push rods look bent ( I think they are called push rods?)

Image

Image

The first push rod looks bent, am I seeing things?
Image

The first and third rod look bent
Image

Mon Feb 25, 2008 12:52 am

Turn the engine over till the push rods have slack in them and spin the rod by hand, you can then tell if they are bent
David

Mon Feb 25, 2008 7:49 am

I agree with Dave. It might just look bent because it is holding the valves open right now and with the rocker arm in the up position it pulls the push rod closer to the inside.

Billy

Mon Feb 25, 2008 10:50 am

I bought a Super A with a bad motor. When I pulled the valve cover I had several bent pushrods. I striatened them and put them back in. Still did not run, but it has bigger issues than pushrods :cry:

Mon Feb 25, 2008 5:31 pm

Hey can I bring my H over????Kevin Looks great!!!!

Tue Feb 26, 2008 12:51 am

Man, I can't wait until I get the AI that far. Looks good from my end her. Keep us posted :D :D :D

Tue Feb 26, 2008 2:07 pm

yes sir! its looking good :wink: .

Tue Feb 26, 2008 2:22 pm

Ron Luebke wrote:yes sir! its looking good :wink: .

Couldnt have said it better myself

Fri Feb 29, 2008 1:41 pm

Sorry, I been on a business trip,

Hey can I bring my H over???? Kevin Looks great!!!!


Bring that H over; we will blast it with my blaster can.

Going to work on the A this week end, I will keep you posted.