Mon Oct 20, 2008 5:57 pm
Does the A-193 plow use the same parts other than the beam and spring bracket as the Cub-193?? I don't have a manual for the A-193 to compare part numbers of the Moldboard and landslide and such. Does it also use a depth control lever to set the drawbar?
Thanks in advance.
Mon Oct 20, 2008 7:36 pm
I think the one for the A was a 14 inch cut, while the one for cub was only 12.
Mon Oct 20, 2008 10:00 pm
As John said, the Super A would typically have a larger bottom than a Cub. Very few if any bottom parts interchange between sizes. The Super A has a two-valve hydraulic system. With the plow, one is used to lift it and the other to control depth. No hand levers are required, just a link from one hydraulic arm to the drawbar.
Tue Oct 21, 2008 4:45 am
Thank you gentlemen. It is much appreciated.
Powered by phpBB © phpBB Group.
phpBB Mobile / SEO by Artodia.