SA Trans.

Farmall Super A, AV, 100, 130, & 140 1939 - 1973

Moderator: Team Cub

Forum rules
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds or one of our site sponsors for your tractor and parts needs.
mikeintn
10+ Years
10+ Years
Cub Star!!
Cub Star!!
Posts: 393
Joined: Tue Nov 21, 2006 12:39 pm
Location: Blountville, TN.

SA Trans.

Postby mikeintn » Thu Jan 15, 2009 2:59 pm

Anyone had Super A Trans. apart, if so can you tell me on the top shaft I think its reverse gear that has the rivet though it how you removed it and what did you use to replace it, I didnt see it listed in the parts book? Thanks Mike
Mike

Jim Becker
Team Cub
Team Cub
501 Club
501 Club
Posts: 12164
Joined: Sun Feb 02, 2003 2:59 pm
Zip Code: 55319
Circle of Safety: Y
Location: MN

Re: SA Trans.

Postby Jim Becker » Thu Jan 15, 2009 6:33 pm

A rivet holds the reverse gear on the upper shaft. I think it is 3/16 x 2 1/4, part number 105088. I don't recall ever removing one. Depending on how big the headed over end is, you can drill or grind it off or knock it off with a chisel. Then knock the rivet out with a punch.

mikeintn
10+ Years
10+ Years
Cub Star!!
Cub Star!!
Posts: 393
Joined: Tue Nov 21, 2006 12:39 pm
Location: Blountville, TN.

Re: SA Trans.

Postby mikeintn » Thu Jan 15, 2009 8:35 pm

Thanks Jim, i've got it out, by grinding the head off and knocking it out, now if I can find one to go back. Mike
Mike

Daniel H.
10+ Years
10+ Years
501 Club
501 Club
Posts: 585
Joined: Mon Feb 03, 2003 1:18 pm
Zip Code: 27055
Tractors Owned: 1951 Super A
1955 Cub Lo-boy
Circle of Safety: Y
Location: NC, Yadkinville

Re: SA Trans.

Postby Daniel H. » Mon Jan 19, 2009 6:20 pm

I used a spring steel roll pin in place of the rivet. It has had many hours of use and no problems.


Image
The four most expensive words in tractor restoration: "We might as well..."

mikeintn
10+ Years
10+ Years
Cub Star!!
Cub Star!!
Posts: 393
Joined: Tue Nov 21, 2006 12:39 pm
Location: Blountville, TN.

Re: SA Trans.

Postby mikeintn » Tue Jan 20, 2009 10:10 pm

Thanks Daniel, I'm sure that would have been fine, but I got one from Messick, Jim was right on the part number. Mike
Mike


Return to “Farmall A, Super A, AV, 100, 130 & 140”

Who is online

Users browsing this forum: No registered users and 0 guests