mounting C-3 mower on A Farmall

[jim turner]

I took a C-3 mower off of a Cub and want to mount it on an A farmall, and I need some help I would like some pictures of the mule drive for an A to C-3 I think I can cut and re-weld the Cub one to make it work on an A, any help would be appreciated.

[bob in CT]

Art C did it.

[artc]

the pulley is a 9". i used part of a cub right angle mule drive ( the pulley setup) i had on hand. it cuts very well at 1/2 to 2/3 throttle and doesn't care how high or thick the grass is.

[jim turner]

Thank you very much artc that should help me out a bunch, one question is that a free run pulley on the tractor?

[artc]

it's a woods pulley i picked up at a John Deere dealer. they are 3 piece affairs that will interface with the 1 1/8 spline. it does not have an overrunning clutch. if i remember correctly, you are looking for 2200+ RPM's at the mower. perhaps someone will chime in with a little more definitive info.