Tue Nov 09, 2010 12:46 pm
so i am working on rebuilding my Touch Control pump on my 1953 Farmall Super A. So i called up my local Case/IH dealer and they said take the pump off and bring it in because there are 2 different pumps, but they have most of the parts for both....ok. fast forward i take off work and my buddy and i drive the 34 miles to get there and they cant match it to anything but they assure me it is a IH pump but dont know if its a whooser, cessna, ect they rattled off like 5 different pump names(what happened to the two?). so they ordered the 2 seals they did not have in stock so i will have to drive back because we are reduced to measuring the shaft and the inner diameter of the seal
so i figured id post it up here and see what yall thought
the two numbers on the side of the pump body are
and here are some pictures of the pump
Tue Nov 09, 2010 4:01 pm
You misread part of the IH part number. It is 383013R94. It is a Wooster pump. This is a later pump, not installed at the factory. There were 2 different pumps installed at the factory, this isn't either of them. The guy at the parts counter should have been able to find it in the 100, 130 or 140 parts catalogs.
Tue Nov 09, 2010 5:13 pm
thanks for the reply, I bet he misread the number as well, he had to use a magnifying glass and the 9 was not easy to read
Tue Nov 09, 2010 7:29 pm
Olred wrote:thanks for the reply, I bet he misread the number as well, he had to use a magnifying glass and the 9 was not easy to read
Except if he knows how IH part numbers work, he would know 8 would be highly unlikely there.
Fri Nov 09, 2012 2:36 pm
I have the 383013R94 Wooster pump.
I bought it used to replace a worn out 360687R91 pump on my 130.
Started cleaning it up to paint today when I thought I should try to put it on the tractor first to see how it would fit.
It does not fit!!!!
Almost fits. Looks like I would have to use the die grinder to take a bit of meat off the 130 just above it under the dist. Only need about 1/16".
Everything I looked up before buying said it would fit.
What to do????
Wed Aug 17, 2016 4:48 pm
I bought one of these pumps that was on a C, hoping to use it on my SA.
What Farmall tractors will this pump fit?
I've searched the internet and it's mostly found advertised as a power steering pump.
Wed Aug 17, 2016 6:08 pm
Gerry, I bought one of these salvaged from a C for my SA. Works great
Wed Aug 17, 2016 6:33 pm
Jim said these Wooster pumps weren't put on at the factory but they have an IH number stamped on them. Do you know if they were sold by IH as replacements?
Did it fit the SA without interference, in the post above he said it needed some grinding to make it fit.
Wed Aug 17, 2016 8:29 pm
I didn't have any issue with mine. I just put it in and everything lined up, no modification required.
Powered by phpBB © phpBB Group.
phpBB Mobile / SEO by Artodia.