It's late and my mind is fuzzy...I know this topic has probably been discussed, because there seems to be something nagging me in the back of my mind. I was about to put the PTO back on the SA today, but thought there MIGHT be a reason to leave it off for the Final Drive removal. Is there any reason I need the PTO off when I remove the Left Final Drive (to swap it out)? Thanks! And good night...will check this in the morning.
Dale #2
SA Final Drive removal
Moderator: Team Cub
2 posts
• Page 1 of 1
-
Dale Finch - 501 Club
- Posts: 1052
- Joined: Tue Apr 27, 2010 11:34 am
- Location: NC, Chapel Hill
- Zip Code: 27517
- Tractors Owned: '55 Cub "Bertha"
'52 Cub "Bobbie"
'48 Super A "Bubba"
'48 Super A (parting out) 
- Circle of Safety: Y
Re: SA Final Drive removal
by artc » Thu Mar 31, 2011 5:34 pm
no reason to leave it off. it will not interfere with the removal of either final drive. now if you intend to replace the transmission seals while you are in that far, i would not install the pto just because it might be in the way of the removal of the axle tube on the right side.
i have all the seal numbers crossed over from IH to CR / SKF numbers if you need them.
i have all the seal numbers crossed over from IH to CR / SKF numbers if you need them.
'If they're tappin', they're not burnin'
http://www.ZagrayFarmMuseum.org
http://www.ZagrayFarmMuseum.org
-
artc - Cub Pro
- Posts: 1640
- Joined: Sun Mar 30, 2003 10:25 am
- Location: CT, Middletown
- Zip Code: 06457
- eBay ID: cmtelephone
- Tractors Owned: 1950 cubs (3), 1948 cub, 1941 A, 1948 H, 1963 B414, 1958 240U, 1948 Oliver 60 industrial, Oliver 70 industrial.1948 super AI (basket case), 1958 450.
2 posts
• Page 1 of 1
Return to Farmall A, Super A, AV
Who is online
Users browsing this forum: No registered users and 1 guest
|
|