Switch to full style
Farmall Super A, AV, 1939 - 1954

Forum rules

Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds or one of our site sponsors for your tractor and parts needs.
Post a reply

Ring Seal on the SA PTO

Fri Apr 22, 2011 6:05 pm

A quick question: while I was replacing the bearing on the SA PTO (previous post), I decided to replace what appeared to be a ragged ring seal (the middle vertical part):

Image

Image

It seemed to be a leather ring that fit on the outside edge of a steel plate that goes into the Belt Pulley Housing. So I ordered one from the IH dealer, and the new one is a large rubber o-ring, rather than a flat leather ring. Anyone have any experience with this? I actually haven't tried it yet, since I got it today, but thought I would ask before I go to the shop, just in case there were any potential problems or tricks to installing it.

Thanks, Dale F

Re: Ring Seal on the SA PTO

Fri Apr 22, 2011 6:42 pm

Just be sure to coat it with oil before you install it.

Re: Ring Seal on the SA PTO

Fri Apr 22, 2011 6:46 pm

OK, thanks, Jim!

Dale F
Post a reply