Clutch & Pressure Plate Advice

Sun May 15, 2011 3:48 pm

We are coming along on my Farmall A resto. and it's time to begin thinging about the clutch, pressure plate, and release bearing. Clutch fingers are worn severely, disk is not shot but figure if I replace the PP might as well replace that. Release bearing has a lot of slop. So, has anyone had any luck finding good used parts? I am not 100% crazy about spending a whole lot more on it, but I don't want to do a shoddy job since we're getting "close" now. Where's the best source for clutch parts?

Al

Re: Clutch & Pressure Plate Advice

Mon May 16, 2011 8:31 am

Al, I have a pressure plate out of an A that looks in good shape. Clutch disc has a lot of meat on it still also. Let me find them and I will shoot you a couple pics.

Dale

Re: Clutch & Pressure Plate Advice

Mon May 16, 2011 1:50 pm

10-4 Dale, lemme know.

Thanks,
Al

Re: Clutch & Pressure Plate Advice

Fri May 20, 2011 1:47 pm

i have a couple clutch/pp's on the shelf if Dale's doesn't work out

Re: Clutch & Pressure Plate Advice

Fri May 20, 2011 4:53 pm

Al, I can not remember where I put it. I will let ya know if I do, but Art might have you covered sooner.

Dale