belt pulley housing

[leroy68]

Pulled mine off bearing looks good but leaking a little around outside of shaft should oil seal fix this problem? What else do i need to do since i have it off?

[leroy68]

Is there suppose to be a gasket behind the plate on the right side where the oil seal is at

Attachments

[Dale Finch]

If you remove the retainer, #48, you'll need to replace the gasket #47. Don't think it was necessary, though, when just replacing the seal #49.

http://www.cleancomputes.com/Cub/Super%20A%20-%20Super%20AV/TC-39B%20Parts%20Catalog/Page%20268.jpg

Dale F