Farmall Cub

Posted: **Thu Jun 23, 2011 10:45 pm**

Pulled mine off bearing looks good but leaking a little around outside of shaft should oil seal fix this problem? What else do i need to do since i have it off?

Posted: **Thu Jun 23, 2011 10:49 pm**

Is there suppose to be a gasket behind the plate on the right side where the oil seal is at

Posted: **Thu Jun 23, 2011 11:26 pm**

If you remove the retainer, #48, you'll need to replace the gasket #47. Don't think it was necessary, though, when just replacing the seal #49.

http://www.cleancomputes.com/Cub/Super%20A%20-%20Super%20AV/TC-39B%20Parts%20Catalog/Page%20268.jpg

Dale F

Farmall Cub

belt pulley housing

belt pulley housing

Re: belt pulley housing

Re: belt pulley housing