Sealing ring

Mon Aug 11, 2014 3:33 am

G'Day all. I was hoping some one may be able to help in locating the sealing ring # 358 208 R1 that fits in the belt pulley drive housing on my SAV its listed in the parts catalog TC-39C as item 13 and it looks like an "O" ring but with a flat section. Case IH. here in Australia list's it as NLA. I was able to get most of the other seals and bearings localy.I have tied the net but no luck. thanks.

Re: Sealing ring

Mon Aug 11, 2014 6:09 am

http://www.messicks.com has three in stock, listed at about $8 US. I'm sure they would ship one to you.

Re: Sealing ring

Wed Aug 13, 2014 12:14 am

Thanks for the heads up Don. I have ordered the ring ,easy site.

Re: Sealing ring

Thu Aug 14, 2014 8:29 pm

I thought it was to good to be true,had to cancel my order $57 for postage to much for me.
Does any one else out there have any suggestions for a supplier? thanks.

Re: Sealing ring

Thu Aug 14, 2014 8:59 pm

Is there any chance the old one is good enough to measure and then check with suppliers there (hydraulic shop, bearing/bushing supplier, etc.)? If it will fit in a regular envelope, I'd think it could be mailed there for just a few $$. You might want to call Messick's and inquire about the postage charge.

Bob