This site uses cookies to maintain login information on FarmallCub.Com. Click the X in the banner upper right corner to close this notice. For more information on our privacy policy, visit this link: Privacy Policy
NEW REGISTERED MEMBERS: Be sure to check your SPAM/JUNK folders for the activation email.
H4 Mag overhaul
Forum rules
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds or one of our site sponsors for your tractor and parts needs.
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds or one of our site sponsors for your tractor and parts needs.
-
- 5+ Years
- Posts: 2
- Joined: Mon Jun 06, 2016 11:57 am
- Zip Code: 36353
H4 Mag overhaul
I have an H4 Magneto that I have been working on to get it cleaned up. When I took the gear timing cover off the larger one that the rotor goes on moved. I thought i put it back in the right place but apparently not. I put it back on the tractor and it gets a good spark. Just not at the right time. I saw one tooth on the smaller gear that is marked but nothing on the larger one. Any help would be appreciated.
- havoc1482
- 10+ Years
- Posts: 987
- Joined: Fri Sep 20, 2013 11:17 am
- Zip Code: 01085
- eBay ID: havoc1482
- Tractors Owned: _______ 1948 Farmall Super A
- Circle of Safety: Y
- Twitter ID: @havoc1482
- Location: Westfield, MA
- Contact:
Re: H4 Mag overhaul
Get the engine at Top Dead Center on the Compression stroke for Cylinder 1. Keep moving the gear until it makes the rotor line up at cylinder number 1 plug wire.
The plastic keyway that the rotor slides onto should have two marks on it. Line up the "R" with the mark on the smaller gear.
The plastic keyway that the rotor slides onto should have two marks on it. Line up the "R" with the mark on the smaller gear.
Mike
I bleed Black & Gold
IH Collectors Club New England (Chapter 18)
Western Mass. (The 413)
I bleed Black & Gold
IH Collectors Club New England (Chapter 18)
Western Mass. (The 413)
-
- 5+ Years
- Posts: 2
- Joined: Mon Jun 06, 2016 11:57 am
- Zip Code: 36353
Re: H4 Mag overhaul
Thanks for your answer. I will get it back together today.
Return to “Farmall A, Super A, AV, 100, 130 & 140”
Who is online
Users browsing this forum: No registered users and 15 guests