splines
Posted: Wed Aug 16, 2006 9:18 pm
how many splines on a 130 pto
The "International" House of Cubs (est. 5/10/1999)
https://www.farmallcub.com/phpBB2/
https://www.farmallcub.com/phpBB2/viewtopic.php?f=170&t=15047
Outside.Eugene wrote:The standard for a PTO is 6 spline, 1 3/8 inch diameter.
Eugene
George Willer wrote:Outside.Eugene wrote:The standard for a PTO is 6 spline, 1 3/8 inch diameter.
Eugene
Eugene wrote:George Willer wrote:Outside.Eugene wrote:The standard for a PTO is 6 spline, 1 3/8 inch diameter.
Eugene
Nope. It's inside diameter when you measure the tractor yoke.
Eugene
George Willer wrote:Eugene wrote:George Willer wrote:Outside.Eugene wrote:The standard for a PTO is 6 spline, 1 3/8 inch diameter.
Eugene
Nope. It's inside diameter when you measure the tractor yoke.
Eugene
I meant the shaft! 1 3/8" is the major diameter. When measuring the yoke the O.D. must be a larger number than the I.D. Otherwise the hole would be on the outside!