Page 1 of 1

splines

Posted: Wed Aug 16, 2006 9:18 pm
by t jackson
how many splines on a 130 pto

Posted: Wed Aug 16, 2006 9:32 pm
by Bigdog
6.

PTO diameter

Posted: Wed Sep 27, 2006 10:49 am
by Ron Thomas
When measuring the PTO diameter is it ID or OD?

Posted: Wed Sep 27, 2006 12:24 pm
by Eugene
The standard for a PTO is 6 spline, 1 3/8 inch diameter.

Eugene

Posted: Wed Sep 27, 2006 2:14 pm
by George Willer
Eugene wrote:The standard for a PTO is 6 spline, 1 3/8 inch diameter.

Eugene
Outside. :D

Posted: Wed Sep 27, 2006 7:44 pm
by Eugene
George Willer wrote:
Eugene wrote:The standard for a PTO is 6 spline, 1 3/8 inch diameter.

Eugene
Outside. :D


Nope. It's inside diameter when you measure the tractor yoke. :wink:

Eugene

Posted: Wed Sep 27, 2006 7:50 pm
by George Willer
Eugene wrote:
George Willer wrote:
Eugene wrote:The standard for a PTO is 6 spline, 1 3/8 inch diameter.

Eugene
Outside. :D


Nope. It's inside diameter when you measure the tractor yoke. :wink:

Eugene


I meant the shaft! 1 3/8" is the major diameter.

When measuring the yoke the O.D. must be a larger number than the I.D. Otherwise the hole would be on the outside! :D

Posted: Wed Sep 27, 2006 8:17 pm
by Eugene
George Willer wrote:
Eugene wrote:
George Willer wrote:
Eugene wrote:The standard for a PTO is 6 spline, 1 3/8 inch diameter.

Eugene
Outside. :D


Nope. It's inside diameter when you measure the tractor yoke. :wink:
Eugene


I meant the shaft! 1 3/8" is the major diameter. When measuring the yoke the O.D. must be a larger number than the I.D. Otherwise the hole would be on the outside! :D


George: Are you giving me the shaft? :P
Eugene