130 Transmission Rebuild
Posted: Thu Feb 12, 2009 11:30 pm
Well,
I've got the tranny on the bench now. Following the service manual from Binder, it says to "remove the snap-ring from reverse gear, and slide shaft out rear of trans".
There is no snap ring that I can see on the gear, but there is a pin through it holding it to the shaft. I'm thinking this is a typo and that pin sure looks like it has to come out for the shaft to move.
I have the drive shaft flange and key removed.
If I can only figure out how to resize pictures I could post some of my progress.
I've got the tranny on the bench now. Following the service manual from Binder, it says to "remove the snap-ring from reverse gear, and slide shaft out rear of trans".
There is no snap ring that I can see on the gear, but there is a pin through it holding it to the shaft. I'm thinking this is a typo and that pin sure looks like it has to come out for the shaft to move.
I have the drive shaft flange and key removed.
If I can only figure out how to resize pictures I could post some of my progress.